Click on the images below to see a larger view.
A special bent-clip type fastener for removable bar grating panels, available in aluminum, stainless steel and galvanized steel.
A plank lug inserted then tack welded between flanges, can serve as an ideal anchor block for plank grating.
A special C-channel frame fastener system used in conjunction with welded anchor blocks between bearing bars. The fabricated frame is held in place by TEK screws that are attached to the anchor blocks. Recommended spacing is between 12" and 16" O.C."
The most versatile clip anchor available. They are especially helpful in holding down riveted grating. Z-Clips are manufactured from stainless steel and are available in 1", 1-1/2", and 2" with a pre-punched hole to accept a 1/4" bolt or TEK screw.
A special formed metal fastener available in multiple sizes to fit any job.
A special friction fastener available in aluminum, stainless steel and galvanized steel used in conjunction with bar grating and embedded grating frames.
For close-mesh aluminum grating (7/16") bearing bar centers, a countersunk land may be drilled by the grating manufacturer for use with a 1/4" dia. TEK screw.
Anchor blocks of 1/4" or 3/16" thick aluminum or steel may be shop welded by the grating manufacturer and used to fasten permanent or removable grating panels. Anchor blocks are recessed thus offering a trip-free surface.
Since grating is typically used to provide multiple level flooring, quite often, grating hatches are needed to facilitate access from one level to another. Ohio Gratings has years of experience in fabricating grating panels with hinges and lift handles, and with locking devices for security purposes. Numerous typical details have been developed, and are on file for customer use. Since these details are standard, they represent the most cost effective methods of fabrication, both from a labor, and from a material availability point of view.
To view more information on the Aluminum Embed Angle Frame view the product page here.